VW Golf 8 with Harman Kardon (HK) | 8-channel DSP sound upgrade | Drive10 Flat subwoofer

Sound system upgrade for the Volkswagen Golf VIII with factory-installed sound system.

By using the Match UP8 DSP amplifier with its calibrated DSP signal setup, both the output power and the tonal quality of the factory-installed Harman Kardon sound system are significantly increased. The amplifier amplifies the individual channels, corrects weaknesses in the frequency response, and applies vehicle-specific time alignment to the signal, which significantly improves the soundstage of the overall system. The Option Drive10Flat BRP subwoofer is included, providing the system with a warm and very powerful bass foundation. Its low profile means the trunk floor remains in its original position. The trunk volume is not reduced.

Scope of delivery:

• DSP amplifier Match UP8 with pre-installed high-power sound setup for Golf VIII with Harman Kardon
• Replacement subwoofer enclosure Drive10 Flat BR-P, ready to connect, fits the spare wheel rim
• Plug & Play wiring harness with power supply connection
• Special tool

Pure power in a handy format:

The Match UP8 DSP is smaller than a sheet of A5 paper, but as powerful as a true giant! With an almost unbelievable 650/1300 watts RMS/max. output power and eight amplifier channels, it will make many a speaker sweat! Such immense power in such a compact space is only possible thanks to Audiotec Fischer's proprietary Class HD technology, which guarantees sensational efficiency and therefore minimal heat generation. This opens up unprecedented possibilities when choosing the installation location. This plug-and-play amplifier fits behind the glove compartment in most vehicles, minimizing installation effort and eliminating long cable runs!

Features MATCH UP8DSP:

• Approximately 650 watts total power, distributed across 8 channels
  
• Extremely powerful 64-bit "Fixed Point" Audio DSP
• ACO – Advanced 32-bit Co-Processor platform for extended functionality
• ISA (Input Signal Analyzer) and InputEQ for easy analysis and compensation of input signals
• Proprietary TuneEQ function for automated adjustment of the output equalizers
• SFX sound effects – Augmented Bass Processing, RealCenter & Intelligent 6-channel high-level input with ADEP.3 circuitry. 1-to-1 channel routing option (IOR) in conjunction with the optional MEC ANA-LOG IN module – same number of high-level inputs and amplifier channels. VCP (Virtual Channel Processing) allows for even more flexible configuration of highly complex sound systems. MEC slot for system expansions such as Bluetooth® HD audio streaming, high-resolution audio streaming via USB, etc. Optical SPDIF input with a sampling rate between 12 and 96 kHz. Mono RCA output for connecting additional amplifiers, e.g., a subwoofer amplifier. SCP (Smart Control Port) for optional accessories such as DIRECTOR, CONDUCTOR, etc. Co.
• Auto Remote Switch
• Start-stop capability down to 6 volts supply voltage
• Extremely compact dimensions and low heat generation thanks to very high efficiency
• RMS / Max. Power
• Output power at 4 ohms: 5 x 65 / 130 watts (front/rear/center)
• Subwoofer output at 2 ohms: 2 x 160 watts RMS
• Amplifier technology Class HD
• Input sensitivity 11.2 volts via high-level speaker input
• Input impedance high-level 13 ohms
• Outputs 7 x speaker outputs
• Frequency range 20 Hz - 20,000 Hz
• DSP resolution 64 bits
• DSP processing power 295 MHz (1.2 billion MAC operations/second)
• Sampling rate 48 kHz
• DSP type Audio signal processor
• Signal converter BurrBrown
• Signal-to-noise ratio analog input > 105 dB (A-weighted)
• Total harmonic distortion (THD) < 0.03%
• Damping factor > 100
• Operating voltage 10.5 volts (max. 5 sec. down to 6 volts)
• No-load current consumption 450 mA
• Dimensions (H x W x D) 45 x 130 x 153 mm

Subwoofer chassis: 25 cm (10")
• Power handling: 300 watts RMS
• Dual voice coil
• Outer diameter: 610 mm
• Height: 130 mm
• Weight: 8.9 kg