Option DSP6 DUC 6-channel power amplifier

If you want to easily but noticeably improve the sound in your camper, have already retrofitted speakers, and are now ready to take the next step, then this set is perfect for your Fiat Ducato, Citroen Jumper, or Peugeot Boxer, each equipped with factory-installed radio preparation. You can easily and quickly integrate the incredibly compact amplifier into your camper using the included cable set via plug & play, and enjoy your sound upgrade in no time.

The 6-channel amplifier powers your front speakers and an optional subwoofer with ample power, allowing you to fully utilize the potential in sound, bass, and volume. Due to its digital design, the amplifier emits very little heat and can therefore be installed invisibly in the radio compartment.

If you have a factory-installed radio, you will also need the following for installation:

In the Ducato Series 7, Boxer and Jumper
In the Ducato Series 8

Two channels are used for the front system, and two additional channels are available each for the rear speakers and a passive subwoofer. The Line Out connection provides two additional channels for connecting further active subwoofers or power amplifiers and controlling them via the DSP.
Technical Specifications DSP6:

• Highly efficient 6-channel DSP amplifier
• Class GD
• 6-channel amplifier / 8-channel DSP
• 6 x 60 watts RMS (4 ohms)
• 4 x 60 watts RMS (4 ohms) + 1 x 150 watts RMS (4 or 2 ohms)
• Channels 5 and 6 are combined in mono operation
• Minimum impedance on all stereo channels: (3 ohms)
• Minimum impedance in mono operation: 1.5 ohms
• ADEP.3 diagnostic protection for trouble-free operation Connection to OEM radios
• Start/Stop compatible up to 5 seconds up to 6 volts
• High-level input (4 channels) with automatic on/off switching
• Frequency band: 20 Hz to 21 kHz
• Integrated 8-channel DSP processor with 358 kHz
• 2-channel line-out up to 3 volts | 3.5 mm jack
• 2-phase synchronous DC/DC converter
• A/D converter: Burr-Brown
• D/A converter: Burr-Brown
• Operating voltage: 10.3 V - 17.5 V
• Power reduction to mid-power mode
• Minimum Dimensions for easy retrofitting: 94 x 149 mm x 32 mm (118 x 149 mm with mounting bracket) 0.6 mA standby current Main connection: 20-pin Molex MiniFit Jr. Subwoofer connection: 4-pin Molex MiniFit Jr. Programming port for DSP EPROM: RJ-45 modular jack Remote control connection: RJ-45 modular jack Power and Protect LEDs