Audi, Skoda, Seat and Volkswagen Plug&Play Sound Upgrade Match

Upgrade amplifier with DSP, including mounting accessories and plug-and-play wiring harness for Audi, Skoda, Seat, and Volkswagen. Do you have a leased vehicle and want to improve the sound of the standard system, but don't want to dismantle the entire vehicle? Here's the solution: a high-quality plug-and-play amplifier with DSP that unlocks unprecedented sound and performance from your vehicle's original speaker system! The set comes with a ready-to-use wiring harness (it's spliced into the factory wiring harness) and a pre-installed, vehicle-calibrated sound setup. Installation is therefore completed in less than 90 minutes, even for inexperienced installers! Powerful performance in a compact package: Barely larger than a smartphone, but with the performance of a true giant! With an almost unbelievable 400/800 watts RMS/max output power and five amplifier channels, this amplifier will push many a speaker to its limits! Such power in such a compact space is only possible thanks to Audiotec Fischer's proprietary Class HD technology, which guarantees sensational efficiency and therefore minimal heat generation. This opens up unprecedented possibilities when choosing the installation location. This plug-and-play amplifier fits behind the glove compartment in most vehicles, minimizing installation effort and eliminating long cable runs! With the optionally available wired remote control, you can switch between optimized sound setups.

Features:

• Highly efficient 5-channel Class HD amplifier with integrated 7-channel DSP
• Minimal dimensions for space-saving and concealed installation concepts
• Lowest heat generation thanks to maximum efficiency
• Latest generation 32-bit AD and DA converters
• Two power options: “HighPower” mode for maximum performance and “MidPower” mode with reduced output power and lower current consumption for plug & play; Play Applications
• Extremely powerful "Fixed Point" audio DSP with 64-bit resolution
• Optical SPDIF input with a sampling rate between 12 and 96 kHz
• Intelligent high-level input with ADEP.3 circuitry and automatic turn-on, therefore no "remote" from the car radio is required
• Start-stop capability down to 6 V supply voltage
• RMS / Max. Power

- @ 4 Ohms High Power mode: 4 x 60 / 120 watts (front/rear channels)

- Mid Power mode: 4 x 35 / 70 watts (front/rear channels)

- Subwoofer output at 4 Ohms High & Mid Power mode: 1 x 90 / 180 watts

- Subwoofer output at 2 Ohms High & Mid Power Mode: 1 x 160 / 320 Watts

• Amplifier Technology Class HD
• Input Sensitivity 11.2 Volts via High-Level Speaker Input
• Input Impedance High-Level 9 - 33 Ohms with ADEP.3
• Outputs 5 x Speaker Outputs
• Frequency Range 20 Hz - 20,000 Hz
• DSP Resolution 64 Bits
• DSP Processing Power 295 MHz (1.2 Billion MAC Operations/Second)
• Sampling Rate 48 kHz
• DSP Type Audio Signal Processor
• Signal Converter Asahi Kasei 24 Bit
• Signal-to-Noise Ratio Analog Input > 99 dB (A-weighted)
Total harmonic distortion (THD) <0.03%
• Damping factor >50
• Operating voltage 10.5 volts (max. 5 sec. down to 6 volts)
• No-load current consumption 280 mA
• Dimensions (H x W x D) 35 x 85 x 110 mm